Leaderboard

IMO, it is not an error, rather it is a warning message indicating that UBC wind analysis results might not be reliable, if the building being analyzed is more than 400 feet high. This is in accordance with requirements of UBC-97 section 1615, which requires that approved national standards (e.g., ASCE 7 etc), shall be used for wind design of buildings over 400 feet in height, among others. Moreover,AFAIK, you may still run your model (even after display of this warning message), by pressing OK button again and again (although analysis results might not be acceptable). Regards.

A/0/a everyone, I am working on a major update for the forum. It would completely change the user experience and hopefully would add a lot of new features to the forum. I will keep everyone posted. Just a heads up for now. Thanks.

Uzair, Good point raised and thanks a lot for your suggestion. I will look into it. Thanks.

I 'm curious to learn more about the expected improvements. However, personally I would like to have your attention to following points: 1. One feature I would like to be added (if not already planned) to the text editor, is user controlled 'Save' button. The present 'auto save' feature, did not work well for me several times in past, as I had to lose considerable data at several occasions (especially in longer posts), because of frequent power outages in our area. 2. It would be better if the user could have control, in setting the time period for 'auto save' function as well. Regards.

I am eager for this.